Adjusting The Drive 4G-S Arms; Troubleshooting Understanding The Drive 4G-S Light - weBoost Drive 4G-S Manual Del Usuario

Adjusting the Drive 4G-S Arms

To change arms, gently lift the arm upward until
the arm slides free from the Drive 4G-S.
To reposition arms, move the arm above a
different slot on the Drive 4G-S and gently slide
the arm down until the arm is firmly in place.
Troubleshooting &
Understanding the Light
The Signal Boost includes a indicator light on
the side of the Drive 4G-S. The indicator light
will either be green or red.
Green indicates that the booster is
powered and operating at maximum gain.
Solid Red indicates that the booster has
shut off on the associated frequencies to
prevent oscillation (feedback).
Need help? www.weboost.com
Fixing Red Light Issues
If one or more lights on the Signal Boost are
red:
1. Make sure all connections are tight.
2. Increase the distance between the outside
antenna and the Drive 4G-S, by moving
them horizontally and/or vertically farther
apart until the light change to green.
Remember to keep the antenna at least 6
inches from any window or sunroof.
3. If more separation is not possible and
the coverage of the booster is too small
contact the weBoost Customer Support
Team for assistance:
866-294-1660.
Lights Off
1. Check connections on the power supply
to see that it is firmly plugged into both the
Drive 4G-S and the power source.
2. If using a DC power supply in your
vehicle, ensure the power supply is
properly inserted. Then check the 12 volt
power from the car socket and the fuse.
Replace the fuse if necessary.
3. If using a power strip in a building, ensure
the power strip is plugged in and turned
on and that power is coming from the
outlet.
NOTE: The Signal Booster can be reset by
disconnecting and reconnecting the power
supply.
For additional descriptions on troubleshooting,
see the install video at weboost.com/us/
drive4G-Svideo .
Customer Support 866-294-1660
Mon.-Fri. 6 am to 7 pm. Sat. & Sun. 8 am to 5 pm MST
5