Fitting The Guides - Casals R1200EA Manual Del Usuario

WARNING: NEVER TIGHTEN THE COLLET NUT
WITHOUT A ROUTER BIT INSERTED
4.1.2. FITTING THE DUST EXTRACTION CHUTE
1. Fit the dust extraction chute to the router as
shown.
2. Use the screws provided to secure the dust
extraction chute.

4.1.3. FITTING THE GUIDES

The tool is supplied with three guides,
• Parallel fence guide: primarily used for straight
cuts, when chamfering or grooving.
• Template guide: Fitted when the tool is used in
conjunction with templates.
• Trammel attachment: Used to move the router in
an arc around a selected pivot point.
4.1.4. FITTING THE PARALLEL GUIDE
1. Connect the rods (A) to the guide body (C),
securing with the screws (D) provided.
2. Fit the assembled guide to the router as shown
on the right.
3. Secure using the parallel guide locking screws
(B). The parallel guide allows the user to follow a
straight edge with accuracy. It is always advisable
to make a trial cut in a piece similar to that to be
worked where possible.
4.1.5. FITTING THE TEMPLATE GUIDE
The template guide allows the user to duplicate
a particular shape, that shape being used as a
template.
NOTE: The template guide can only be used if the
dust extraction chute is fitted.
1. With the tool upside down, remove the two
screws securing the dust extraction chute in place.
2. Fit the template guide with the raised boss fac-
ing the workpiece.
3. Secure using the two screws.
4.1.6. FITTING THE TRAMMEL ATTACHMENT
1. Remove one of the rods from the parallel guide
and insert it into position on the router. Secure in
place using the parallel guide locking screws.
2. Loosen the wing nut on the trammel attachment
and slide the attachment on to the parallel guide
rod as shown.
3. Adjust the height of the pivot point by turning the
screw.
4. Tighten the wing nut to lock the pivot point in
place and the trammel attachment to the rod.