Sunex Tools 7700B Manual De Instrucciones página 4

OWNER'S MANUAL
5. Make sure the chain is very tight when securing the transmission to the head and before raising or lowering the transmission.
6. Remove the transmission from the engine according to instructions in the vehicle service manual.
7. Once the transmission has been disconnected from the engine, very slowly turn the release valve in a counterclockwise direction.
Make sure the jack's head and transmission do not hang up on any under car components, wiring, fuel lines, etc. Continue to lower
the load all the way down.
8. When installing a transmission, follow the above instructions but in the applicable order and according to the vehicle
manufacturer's installation procedure.
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the jack in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust, or any
other harmful elements. The jack must be cleaned of water, snow, sand or grit before using.
2. The jack must be lubricated periodically in order to prevent premature wearing of parts. A general purpose grease must be applied to all
fittings, caster wheels, tilt screws but no hydraulic compontents. Worn parts resulting from inadequate or no lubrication are not eligible
for warranty consideration.
3. It should not be necessary to refill or top off the reservoir with hydraulic fluid unless there is an external leak. An external leak requires
immediate repair which must be performed in a dirt-free environment by an authorized service center.
IMPORTANT: In order to prevent seal damage and jack failure, never use alcohol, hydraulic brake fluid or transmission oil in the jack.
Use Chevron Hydraulic Oil AW ISO 32 or its equivalent Unocal Unax AW 150.
4. Every jack owner is responsible for keeping the jack labels clean and readable. Use a mild soap solution to wash external surfaces of the
jack but not any moving hydraulic components.
5. Inspect the jack before each use. Do not use the jack if any component is cracked, broken, bent, shows sign of damage or leaks
hydraulic fluid. Do not use the jack if it has loose or missing hardware or components, or is modified in any way. Take corrective
action before using the jack again.
6. Any hydraulic repairs within the warranty period must be performed by an authorized service center.
TROUBlESHOOTING
Problem
1. Unit will not lift load.
2. Unit will not sustain load or feels "spongy"
under load.
3. Unit will not lift to full height.
4. Unit still does not operate.
7700B
PEDESTAL TRANSMISSION JACK
Action
Purge air from hydraulic system by following procedure
under SETUP.
Purge air from hydraulic system as above.
Purge air from hydraulic system as above.
Contact an authorized service center from enclosed list.
4
MODEL 7700B
CAPACITY: 700Lb.
Rev. 05/16/12