Metalux SNF Instrucciones De Instalación página 2

Installation Instructions – SNF/SSF
INSTALLATION
SNF/SSF Installation
1. Flip socket track in place (Figure 1.).
2. Apply screws on the sides of channel (T12HO and
Slimline, SSF only).
3. Install channel cover with quarter turns provided.
Conduit Installation
1. Remove KO and install fitting (Figure 2.).
2. Flip socket track in place.
Refer to Step 2 of Assembly Instructions for remaining
installation.
Row Aligner Instructions
1. Bend the row aligner and separate it from socket track
(Figure 3.).
2. Insert row aligner into channel. Insert wire holder if
running a harness along the row of fixtures.
3. Add screws on the side of channels (SSF only).
4. Insert harness into wire holder if applicable.
n ote: Endplate must remain in place at end of row.
Figure 1.
2
Figure 2.
Figure 3.
installation instructions – SnF/SSF
0590SNFINS ADF140680 www.eaton.com
Row Aligner
Wire Holder