Monster MST3304BKFBH Manual Del Propietário página 4

ASSEMBLY INSTRUCTIONS
Step 4: Attaching Bottom Tray and Drawer
Assembly to Legs and Bumpers
Align holes in legs and bumpers with matching holes
in bottom tray and drawer assembly as shown in figure
4. Insert bolts through legs and bumpers and into
bottom tray and/or drawer assembly and secure with
leg star bolts until all side holes have been attached
and hand tightened.
Step 5: Attaching the Handle
Align the hole on the handle with the second hole
down on the drawer assembly and (unattached) leg as
shown in figure 5. Insert M8 x 19 handle bolts through
handle, through the legs and bumpers, and into the
drawer assembly as shown in figure 5. Secure with
star bolts from handle bolt kit and hand tighten.
Attach remaining M8 x 17 bolts (on the opposite side
from push handle) directly into legs.
Step 6: Tightening Bolts (not shown)
Use a T40 driver to tighten all bolts.
MST3304BKFBH/MST3304GFBH/MST3304MBFBH/MST3304TGFBH
4.
5.
6.
4 rev. 10/02/18