Publicidad
Idiomas disponibles
Idiomas disponibles
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY.
THIS INSTRUCTION MANUAL CONTAINS IMPORTANT
SAFETY INFORMATION.
READ THIS INSTRUCTION MANUAL
CAREFULLY AND UNDERSTAND ALL
INFORMATION
THIS TOOL.
• Always
operate,
tool
in
accordance
National
Standards
Portable Air Tools (ANSI B186.1) and any other
applicable safety codes and regulations.
• For
safety,
top
performance
durability
of
parts,
at 90 psig; 6.2 bar max air pressure with 3/8"
diameter air supply hose.
• Always
and face protection when operating or
performing maintenance on this tool.
Always
when using this tool.
• High
permanent hearing loss. Use hearing
protection
employer or OSHA regulation.
• Keep the tool in efficient operating condition.
• Operators and maintenance personnel must be
physically able to handle the bulk, weight and power
of this tool.
• Air under pressure can cause severe
injury. Never direct air at yourself or
others. Always turn off the air supply,
drain
detach tool from air supply before
installing, removing or adjusting any
accessory on this tool, or before
performing any maintenance on this tool.
Failure to do so could result in injury.
Whip hoses can cause serious injury.
Always check for damaged, frayed
or loose hoses and fittings, and replace immediately. Do
not use quick detach couplings at tool. See instructions for
correct set-up.
• Air powered tools can vibrate in use. Vibration,
repetitive motions or uncomfortable positions over
extended periods of time may be harmful to your hands
SX225B
BEFORE
OPERATING
inspect
and
maintain
with
American
Institute
Safety
Code
and
maximum
operate
this
wear
impact-resistant
wear
hearing
protection
sound
levels
can
as recommended by your
hose
of
air
pressure
and arms. Discontinue use of tool if discomfort, tingling
feeling or pain occurs. Seek medical advice before
resuming use.
• Place the tool on the work before starting the tool. Do
not point or indulge in any horseplay with this tool.
this
of
• Keep body working stance balanced and firm.
Do not overreach when operating the tool.
tool
• Anticipate and be alert for sudden changes in
motion during start up and operation of any
power tool.
eye
• Do not carry tool by the hose. Protect the hose
from sharp objects and heat.
cause
• Drill bits can bind suddenly and cause rotation of the
work piece or tool, causing injury to arms and/or
and
shoulders. Enough torque is generated to cause falls.
Always use sharp bits. Use less downward pressure at
breakthrough.
• Do not lubricate tools with flammable or volatile liquids
such as kerosene, diesel or jet fuel.
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace any damaged
labels.
• Use accessories recommended by Sunex Tools.
2
• Slipping, tripping and/or falling while
operating air tools can be a major
cause of serious injury or death. Be
aware of excess hose left on the walking
or work surface.
• Tool shaft may continue to rotate
briefly after throttle is released. Avoid
direct contact with accessories during
and after use. Gloves will reduce the risk
of cuts or burns.
• Keep away from rotating end of tool.
Do not wear jewelry or loose clothing
Secure long hair. Scalping can occur if
hair is not kept away from tool and
accessories. Choking can occur if
neckwear is not kept away from tool and
accessories.
Rev. 02/01/05
Publicidad
