When watch is powered on and connected by Bluetooth with your phone, operation is as below:
Time mode interface:
Date, time, day of week, amount of steps
and burnt calories.
Pedometer interface:
Heart rate interface:
Show the heart rate detection data
Blood pressure detection interface:
Show blood pressure detection data.
1. Long press touch key to show product's
information.
It will show software version, BT MAC address,
battery level and BT connection icon.
When BT icon appear it means device is
paired with phone.
2. Long press side key to enter into the
shutdown interface.
Power OFF – long press touch key to power
off device
Reset – long press side key to delete all
data saved in device
Shows current steps amount, distance and
burnt calories.
1. enter to heart rate interface to measure
heart rate. After around 15 seconds device
will start measurement. After about 45
seconds of continous testing device will
show final result followed by short
vibration.
Your result will be saved and next time if
you long press touch key on HR interface
device will show graph chart with previous
results.
1. enter to blood pressure interface to start
test. After about 40 seconds blood pressure