Important - FUXON RL-MINI EB Instrucciones De Funcionamiento

Technical facts and references
With 3 LEDs
u
Tested and approved in accordance with
u
the German Road Traffic Licensing Regula-
tions (StVZO)
The reflector surface of the taillight must
u
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
Nominal performance: 0,6 W
u
Input voltage: 6V (6-12V) DC AC
u
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!
Connecting the rear-light:
Atachment of the rear-light:
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated screws,nuts and washers to the carrier of the
u
bicycle.
When attaching the tail light, make sure that the screws are tightened so tightly that the
u
light can not.
50 mm
Before every journey, ensure that the headlight is not covered.
REAR LIGHT »RL-MINI EB«

Important:

The 6-12 V DC version is marked with the
symbol DC AC. It should be noted that the
use of the 6-12 V DC AC version is only
permitted for bicycles with electric assisted
pedalling (e-bikes) if, following a discharge-
based shut-down of the support drive, an
uninterrupted power supply to the lighting
system is ensured for at least two hours, or
if the drive motor can be used temporarily
as a generator in order to continue to supply
power to the lighting system.
The light is switched on/off using the bike
control unit with pedal assistance.
Rear light cable +
(black)
Rear light cable -
black+white)
Input
Reference axis paralel
to vehicle longitudinal
axis
RL-Mini EB
DC AC 6 V (6-12 V)
0,6 W
Input: DC AC
6 V (6-12 V)
GB