GE Advantium PSB9240DF Instrucciones De Instalación página 9

Preparation
NOTE: MODEL ZSC2202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION
WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL.
PREPARE THE OPENING
Installation over a GE/Monogram Oven:
30"
21"
45-1/4"
Min.
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
double oven with the combined installation of
an Advantium 240V and a single oven, use the
dimensions shown. The middle rail separating
the two openings may need to be larger than
the 2" minimum shown.
Installation Preparation
WITH
(CONT.)
23-1/2"
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2x4 or 2x2
25-1/4"
Runners all
Min.*
Four Sides
2" Min.
(3" recommended)
Per Oven
Requirement
an Accessory Storage Drawer
PREPARE THE OPENING
Installation over a GE/Monogram Oven and
Warming Drawer:
30"
45-1/4"
Min.
Per warming drawer requirement
* For existing cutouts, a maximum width of 28-1/2"
is acceptable. If the opening is slightly wider,
secure a furring strip on each side of the cutout
for securing the oven.
NOTE: Additional clearances between the cutouts
may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct
the required interior depth and height. See Warming
Drawer installation instructions for details.
CAUTION:
mounting surface must be capable of supporting
the cabinet load, in addition to the added weight
of this approximate 80-pound oven and 30-pound
drawer, plus additional oven loads of up to 50
pounds or a total weight of 160 pounds.
PRECAUCIÓN:
personal, la superficie de montaje debe poder
soportar la carga del gabinete, además del peso
aproximado de 80 libras del horno y las 30 libras
del cajón, más las cargas adicionales del horno
de hasta 50 libras o un peso total de hasta
160 libras.
9
(CONT.)
23-1/2"
25-1/4"
Min.*
21"
Per Oven
Requirement
For personal safety, the
Para seguridad
Construct
Solid Bottom
Min. 3/8"
Plywood
Supported by
2x4 or 2x2
Runners all
Four Sides
2" Min.
(3" recommended)
2" Min.