Glacier bay VWD1066BLS-1-HDU Guía De Uso Y Cuidado página 8

READY-TO-DISPENSE INDICATOR LIGHTS
RED
BLUE
YELLOW
Operation
1. DISPENSING ROOM AND COLD WATER
2. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory
with the cold water temperature control factory "default
setting" positioned for "Energy Star" compliance
(identified to the side). This setting will deliver cold water
temperatures between 8°C ~ 10°C (46.4°F ~ 50°F) The
cold water temperature can be adjusted, (using a flat
screwdriver) by rotating the adjustment screw clockwise
or anti-clockwise between "Min" (cool) and "Max" (colder)
until the desired temperature is reached. NOTE: Any
change/adjustment to the cold water temperature control
may effect Energy Star efficiency.
FLASHING
STEADY ON
OFF
STEADY ON
OFF
FLASHING
OFF
1
1
Heater (hot water tank) is operational
The hot water has reached optimum
temperature and is ready for dispensing
Hot water tank heating system is off, however
water within the tank may still be very hot,
always exercise caution when dispensing and/
or draining water from the hot water tank
The cold water has reached optimum
temperature and is ready for dispensing
The cooling cycle is in progress. It is possible
to dispense water during the cooling cycle,
however, optimum cooling temperature may
not yet be achieved
Low water level inside internal reservoir. The
water bottle is empty
The status of all water levels are normal
2
2
3
3
ENERGY STAR FACTORY
DEFAULT SETTING
TEMP
Min.
Max
COLD WATER