Razarsharp UltraTrimmer Manual De Instrucciones página 6

ADVANCE AND AUTOMATIC CUTTING OF THE NYLON LINE
1 - With the equipment running:
•
Slightly press the spool against the ground. The nylon line will automatically be released. The cutting blade
fixed to the protection device will limit the amount of wire released.
•
Press the spool against the ground as many times as necessary.
•
In order not to damage the equipment or the protection device, only press the metal part of the spool (1)
against the ground.
2 - You may want to carry out this operation manually:
•
Unplug the equipment.
•
Press the metal part of the spool (1) with one hand and with the other pull the nylon line (2) in the necessary
length. If the wire exceeds the ideal length, it will be cut by the blade fixed to the protection device.
FIXING THE EXTENSION CORD TO THE EQUIPMENT
There is a locking system in the lower part of the handle to facilitate usage and to prevent the extension cord from
being disconnected from the wall outlet. To use this system:
•
Put the extension cord in hole.
•
Pass the cord over the lock.
•
Connect the equipment plug to the extension cord.
•
Before begning to cut the grass, set the adjustable support (figure below) according to the grass length.
•
Hold the equipment with one hand by the adjustable handle and press the trigger key with the other.
•
If the grass is very long, the grass should be cut in stages, maintaining a suitable height in relation to the
ground to avoid overloading it.
•
For better performance of your mower, mow the lawn alternating frontward and backward movements, slowly
advancing on the area to be cut (see figure).
•
Never allow the spool to touch the ground, it causes overload and may burn the motor of your mower.
2
1
HOW TO CUT THE GRASS
1
5