vdodayton CI 3000 Manual De Instrucciones página 5

G Installation instructions
IMPORTANT INFORMATION
A
The system must only be installed by trained
specialists.
A
Observe automotive industry quality
standards.
A
Fire hazard! When drilling, care must be taken
not to damage concealed wiring harnesses, the fuel
tank and fuel lines.
A
Never drill into supporting or safety-relevant
body parts.
It is essential to observe the following when
installing components in the passenger
compartment:
A
Ensure that the driver has a clear all-round
view.
A
Increased risk of injury in the event of an
accident. Do not install components in the inflation
range of the airbag or in areas where the head or
knees may knock against them.
A
Only install in vehicles with 12V on-board
voltage and negative earth. Risk of malfunction,
damage and vehicle fire if installed in unsuitable
vehicles (e. g. heavy goods vehicles, buses).
A
Do not damage safety system wiring (airbag
etc.). (Wiring is normally specially marked, for
example by labels.)
A
Do not use test lamps to test the voltage, since
excessively high currents can damage / destroy
electronic components.
A
Do not use pinch or cut connectors for
connecting the power supply. Solder these wiring
connections. Insulate all solder points with shrink
hose or insulating tape.
A
Fit toothed washers at earth connections to
the vehicle body. If necessary, remove paint and
dirt beforehand. Subsequently, protect bare metal
against corrosion.
A
In order to ensure perfect installation, use only
the original components supplied. The use of non-
authorised components may result in malfunction.
A
Do not install the unit in positions where it is
exposed to high temperatures, dust, dirt or
excessive vibration (e.g. due to direct sunlight or
heating vents).
Scope of delivery, Fig. 1
1 Communication Interface Module
2 4 self-tapping screws 4.2 x 16 mm
3 Power supply lead and navigation lead
4 Installation and operating instructions
Recommended installation locations, Fig. 2
The CI 3000 Communication Interface can be
installed e.g. in/under the glove compartment,
under the dashboard or under the seats.
Accessibility of the expansion ports and other
connectors for subsequent retrofitting or
conversion should also be taken into account
when selecting the installation location.
1
Taking safety precautions and installation,
Fig. 3
A
Before starting work, disconnect the earth
lead from the negative terminal of the vehicle
battery in order to prevent short circuits. At the
same time, follow the vehicle manufacturer's safety
instructions (alarm system, airbag, immobiliser,
radio coding etc.).
A
The CI 3000 must on no account be installed in
the following locations:
Near electric motors or other vehicle
electrical system assemblies.
Near wiring harnesses of the vehicle
electrical / electronic system.
At locations where it is exposed to high
temperatures or direct sunlight.
At locations with excessive humidity,
spray water or dirt.
Installation
The CI 3000 can be secured in a suitable
installation location, using the screws supplied
with the unit. For this purpose, four fastening
tabs are provided on the CI 3000 housing.