Set Video Output Of Nmp-530 - ViewSonic NMP-530 Manual De Instrucciones

7. S
ET
By default, the video output is set to S-Video. But, you can choose any one of the following
connections if you prefer, depending on the type of display input you want to use.
HDMI:
E
N
S-Video:
G
L
I
Component: Using the S-Video/YPbPr adapter.
S
H
Composite:
To change the output setting, login to the NMP-530, under Management click Video/
Audio. The screen shown below appears. For more information, see the Video/Audio
Configuration section in this guide.
1. In the TV Mode field, click the down arrow for the pull-down menu and select one of
the resolutions required by your display (PDP or LCD).
2. If any changes were made to this screen, do the following:
• To enable the changes, click Apply
• To save the changes, under Administration click Save Configuration > click Save.
10
V O
IDEO UTPUT OF
Connect a HDMI cable from the back of the NMP-530 to the HDMI interface
on the back of the display.
Default. Connect an S-Video cable from the S-Video interface on the back
of the NMP-530 to the S-Video interface on the back of the display.
Using an RCA cable.
Show IP
NMP-530
ViewSonic NMP-530