Channel Settings - Heath Zenith 6022 Guia Del Usuario

Note: Most installations will not require you to change any of the dip
switches on your plug-in module or remote control.
The remote control and outdoor
module communicate by using chan-
nels that can be changed by sliding
dip switches into the ON or OFF [on
some switches the numbers 1 (ON)
and/or 0 (OFF) are used] position on
both the remote control and outdoor
module. The channel is factory set;
however, there are 3 switches (8
selectable channels) that allow you
to expand your system and prevent
outside interference. Other wireless
products may cause interference and
the system may not function properly.
Follow the instructions below for set-
ting a new channel.
1. Open the cases and locate dip switches on both the remote control and
outdoor module (see Figure 5).
2. The remote control and outdoor module both have two positions (ON and
OFF) on each of the four dip switches. Dip switches 1 through 3 are used
for setting the channel. Use the table below to set channel 2 after setting
channel 1. Note: The channels must be programmed according to the table
below for all 4 functions of the remote control to work properly. The receiver(s)
must match the code settings for channel 1. Use the table below to set the
corresponding code for channel 2.
3. To change the channel, slide dip switches to ON or OFF as needed. It is
recommended to only change one dip switch at a time and then check to see
if the system is functioning properly. Note: Dip switches in positions 1 through
3 must be in the exact same
configuration on both the remote
control and outdoor module for
this system to function properly.
598-1108-04

Channel Settings

Dip Switches - Shown
Channel 1 Transmitter
3
Keyholes
Access
Door
ON DIP ON DIP
1 2 3 4 1 2 3 4
in the OFF Position
(Factory Default)
Figure 5
Channel Setting Codes
and Receiver(s)
0000
0010
0100
0110
1000
1010
1100
1110
0 = OFF
Channel 2
Transmitter
0001
0011
0101
0111
1001
1011
1101
1111
1 = ON