Operating - EarthWise LB21020 El Manual Del Propietario

TO TURN THE TOOL ON
The On/Off switch is integrated in the
handle. Pull the switch trigger against
the handle and hold to power on the
blower.
TO TURN THE TOOL OFF
Release the switch trigger.
WARNING: Do Not use the blower with
any type of accessory or attachment.
Such usage might be hazardous.
AIR SPEED CONTROLS
Rotate the speed control wheel
to accelerate or decelerate air
speed. The speed control
wheel is marked with 1 to 6.
One is the lowest speed and 6
is the highest.
If you drop the blower, carefully inspect it for damage. If the
tube is broken, housing cracked, or handles broken or if you
see any other condition that may affect the blower's operation,
call our customer service help line at 1-800-313-5111 for
assistance.
To clean the tool, make sure the battery is detached from the
unit, then use only mild soap and a damp cloth. Never let any
liquid get inside the tool; never immerse any part of the tool into
a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed
by a qualified individual always using identical replacement
parts.
Problem
- Unit does not run - Battery not making contact
- Battery not installed properly
- Battery not charged
- Battery not inserted into charger
- Battery will not charge
- Charger not plugged in
- Surrounding air temperature too hot
or too cold

OPERATING

Switch trigger
Speed Control Wheel
MAINTENANCE
TROUBLE SHOOTING
Possible Cause
Model LB21020
BLOWING
Blower can be used to clean corners, fences, walls, wooden areas or
beneath cars. Be careful how you point
the jet of air as it could move heavy
material and cause injury or damage.
Turn the switch to on, point the jet of air
in front of you and move forward slowly
to gather together the leaves or to
move the leaves from inaccessible
areas.
Avoid collisions with hard objects which
could damage your blower.
Keep bystanders and animals at least 5
m (15 feet) away from the working area.
Make sure that the switch is in "OFF" position, the battery pack is
disconnected and all the rotating parts are at a standstill before
cleaning, carrying out inspections or moving from one place to
another.
Do not put part of your body such as hands and fingers in the exhaust
opening.
Do not switch the machine on in enclosed or poorly ventilated spaces
or in the presence of flammable and/or explosive substances such as
liquids, gas and powders.
WARNING: After battery has been fully depleted, make sure switch is
in the "OFF" position.
CAUTION: Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact with plastic
parts. They contain chemicals that can damage, weaken or destroy
plastic.
Fertilizers and other garden chemicals contain agents which greatly
accelerate the corrosion of metals Do not store the tool on or adjacent
to fertilizers or chemicals.
Possible Solution
- Check battery is fully inserted
- Check that battery is securely connected to the blower.
- Check battery charging requirements
- Insert battery into charger until red LED appears
- Plug charger into a working outlet
- Check current at receptacle by plugging in a lamp or
other appliance
- Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
- Move charger and tool to a surrounding air temperature
of above 39 degree F (4 degree C) or below 104 degree F
(40 degree C)
5