Tabla De Contenido - Cisco Systems Linksys SD205 Guia Del Usuario

COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. Copyright © 2003 Cisco Systems,
Inc. All rights reserved. Linksys is a registered trademark of Cisco Systems, Inc. Other
brands and product names are trademarks or registered trademarks of their respective
holders.
FCC STATEMENT
Every 10/100 Switch has been tested and complies with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used according to the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment or devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
EC Declaration of Conformity (Europe)
In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC, and
Amendment Directive 93/68/EEC, this product meets the requirements of the following
standards:
• EN55022 Emission
• EN55024 Immunity
SD205_SD208_SD216-EU-UG-30606NC JL
2
Table of Contents
Chapter 1: Introduction
The 10/100 Switch
Features
Chapter 2: Getting to Know the 10/100 Switch 5
Overview
Front Panel LEDs
Back and Side Panel Features
Chapter 3: Connecting the 10/100 Switch
Overview
Connecting Network Devices
Placement Options
Appendix A: Specifications
Environmental
Appendix B: Warranty Information
4
4
4
5
5
5
7
7
8
9
10
11
12
3