Black and Decker SMART CODE 25604-01 Manual De Instalación Y Programación página 6

8. Continued.......
d. See example for turnpiece
position for right hand door (RHD)
and left hand door (LHD) when
bolt is fully thrown (locked) and
fully retracted (unlocked).
9. Programming a User Code.
● A programmed code can be from four (4) to eight (8) digits long.
● Up to 2 user codes can be entered.
● Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (a).
Program
Button
Programming the 1st user code.
a. Press the program button on the interior unit once.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
d. Extend the bolt by pressing the "LOCK" button and re-enter the code to
test. The bolt should retract to the unlocked position. If it does not unlock,
repeat steps (a) through (c).
Programming the 2nd user code.
a. Press the program button on the interior unit twice.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the "LOCK" button to save code.
d. Extend the bolt by pressing the "LOCK" button and re-enter the code to
test. The bolt should retract to the unlocked position. If it does not unlock,
repeat steps (a) through (c).
6
TURNPIECE
(RHD) LOCKED
TURNPIECE
(LHD) LOCKED
(RHD) UNLOCKED
(LHD) UNLOCKED
5 6
3 4 7 8
1 2 9 0
LOCK
Button