StarTech.com ARMSTS Guia Del Usuario página 24

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Press the pneumatic arm lever to extend the pneumatic arm.
Caution: To prevent the pneumatic arm from rising too quickly, hold down the arm of
the base as you squeeze the lever.
2. Turn over the assembled pneumatic arm and line up the four holes on the
pneumatic arm (1) with the four holes on the base (6).
3. Use the M4*55 Allen wrench (12) to insert four M6*25 screws (15) through the holes
on the pneumatic arm and into the base.
4. Turn the Allen wrench clockwise to tighten the screws.
Warning! Do not over-tighten the screws (tightening torque is 1.5 Nm).
Instruction manual
Instruction Manual
1
6
12
15
12

Publicidad

Tabla de contenido
loading

Tabla de contenido