Panic Function; Operating Modes; Arm (Alarm) Mode; Setting The Switch-On Delay - Schwaiger SECURE-4-YOU Serie Manual De Instrucciones

USER MANUAL HG1000 532

7.8. Panic function

By pressing the HOME
In this case, the siren of the central unit is immediately triggered and sets off an alarm. If a further outer siren
is linked to the system, this is also set off.
In order to deactivate this alarm press either
central unit.

8. OPERATING MODES

The system has a total of 3 modes: (ARM,
These can be adapted individually, in line with requirements.

8.1. ARM (Alarm) mode

If this mode is activated, then by subsequent recognition through the sensors, the sirens sound and the central
unit flashes every 2 seconds.
Basic setting in ARM mode:
Sensor
Door/window sensor
Door/window sensor
Movement sensor

8.1.1. Setting the switch-on delay

The switch-on delay is important, so that you are able to leave the monitored area without setting off the alarm
directly. The standard setting here is 20 seconds.
If you wish to enter this timespan, please proceed as follows:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
switch-on delay setting.
26
and ALERT buttons at the same time, what is known as a panic alarm is set off.
DISARM
ALERT
Zone
1
2
8
Step 2
Now enter
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now the set time delay is displayed.
"4"
(Factory settings: 20 seconds)
Press the
you need to, until the duration you
desire is displayed.
(possible range: 10 seconds –
60 seconds)
on the remote control or enter the
and HOME).
Mode/Status
ARM
ARM
ARM
"1-2-3-4" or your
and confirm this
„4" button as often as
4-digit PIN
Step 3
If you enter the PIN correctly, the
display now shows the following
image:
Step 6
Then confirm the set time using
. The centre now automatically
switches into the Standby Mode
again.
in the