Publicidad
Idiomas disponibles
Idiomas disponibles
1. Slowly press the primer bulb 5-10 times.
After the 7th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer until
you see fuel in the bulb.
2. Push the choke button in to set the choke to FULL
CHOKE position.
Do not squeeze the throttle trigger because the
choke will be pop out automatically.
the front handle to securely hold the unit in place.
4. Pull the starter grip /cord until resistance is detected.
Rapidly pull 3 to 5 times or until you hear engine turn
over or begin to start.
5. If engine does not start, release choke by squeezing
throttle trigger and the choke button pops out.
a.Engine is now in the run position.
b.Rapidly pull starter grip/cord until engine starts.
6. Allow the engine to run for 10 seconds,then squeeze
throttle to provide fuel to engine and use for intended
task.
The choke button is only used when starting
a cold engine. Never push the choke button in once
the engine has been turned over or run. Otherwise the
engine could be damaged.
DO NOT push choke button in.
1. Make sure the primer bulb has fuel inside.
2. Rapidly pull starter/grip until engine starts.
3. Squeeze throttle to provide fuel to engine.
To stop the engine, depress the STOP switch to the
stop position "STOP".
This Stop switch will come back to the ON
position automatically.
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
Do not return this product to the retail store where it
was purchased. Please call our Customer Service
Department for any issues you may have. For Help
Call: 1-800-261-3981
not bend over.
arm slightly bent.
straight.
from the rotating cutting attachment and hot surfaces.
10
On/Off Switch
(I = On / STOP = Off)
Primer Bulb
Choke
Handle
Starter Rope Grip
Throttle Control
Throttle
Lockout
Throttle Control
WWW.SENIXTOOLS.COM
Publicidad
