Sears CRAFTSMAN 247.770990 Manual Del Operador página 7

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
Figure 
Rope Guide
B
A
Figure 
B
A
Figure 
www.mymowerparts.com www.mymowerparts.com
ASSEMBLY
ATTACHING THE HANDLE
1. Remove the hairpin clips from the handle brackets and remove the
carriage screws and wing nuts from the lower handle.
a. Place the bottom holes in lower handle over the pins on the
handle brackets and secure with hairpin clips. See Figure 2.
b. Insert carriage screws through upper hole in lower handle from
the inside and secure with wing nuts. See Figure 2.
2. a. Unfold the upper handle until it aligns with lower handle. Make
sure the rope guide is on the right side of upper handle. See
Figure 3.
IMPORTANT: Make sure the cables are routed outside the lower
handle. Also, do not crimp the cables while lifting up the handles.
b. Secure the two handles by tightening the handle knobs (carriage
bolts must be seated properly into the handle). See Figure 3.
3. Pull the two cable ties attached to the cables tight approximately
8 inches from each cable end and place the cables into the cable
guide. See Figure 3.
4. Loosen the wing nut that secures the rope guide to the right side of
upper handle.
a. Pull the starter rope out of the engine slowly. See Figure 4.
b. Slip the starter rope into the rope guide. Tighten the wing nut.
See Figure 4.
ATTACHING THE HOSE
ASSEMBLY
5. a. Slide hose adapter of hose assembly into the base adapter
located on the left front of the Yard Vacuum. See Figure 5.
b. Pull spring loaded pin out on the base and align pin with the first
hole (closest to the end of the tube) in the hose adapter.
c. Release the pin to lock the hose in place.
A
Align pin
with this
hole.
7
B
Figure