bluefin BF DC-25T Manual De Instrucciones página 3

MAINTENANCE TROUBLESHOOTING
TURNING OFF THE APPLIANCE
- Empty the appliance
- Disconnect the power supply
- Pull out the connect cable
- If you will not be using the appliance for a longer period, clean it with a soft cloth and leave
the lid slightly open
CLEANING / MAINTENANCE
- Always disconnect the power supply before cleaning the appliance
- Clean the inside of the appliance whenever necessary using a warm solution of water and
bicarbonate of soda (one tablespoon to every two litres of water), and dry with a soft cloth
- Dirt from the condenser should be cleaned by a qualified technician when necessary
- Do not use abrasive cleaning products
- Ensure that the air vents are free from dust or dirt particles
- It is normal to hear gurgling sounds caused by the flow of refrigerant when each cooling
cycle ends
- The surface temperature of the compressor can reach 70-90°C when running
SPECIFICATION
- The noise emitted by the cooling fan on the condenser is normal
- When moving the appliance, the angle between the cabinet and the ground should not be
less than 45°C in order to protect the compressor and refrigerating system
- Position the appliance in a dry and well-ventilated place. Keep the freezer away from
direct
sunlight, heaters and corrosive gases
- The normal operation of the appliance depends on the heat radiation of the condenser. For
the initial use, the packing foam must be taken off and at least 150mm space must be left
around the freezer
DISPOSAL
- If you wish to dispose of the product, ensure that correct disposal is carried out
- The product should not be treated as household waste
- The product should be taken to an appropriate waste collection point for the recycling of
electrical and electronic equipment
- Ensure to dispose the product in accordance with the applicable disposal regulations