Vision TECHCONNECT CONTROL El Manual Del Propietario página 13

7. EDIT CODES Click on edit. You can only edit codes that have been created by users. The
preset library Vision includes cannot be modified.
8. EXTENSION PANELS If six buttons isn't enough you can use two panels side by side:
a. Assign commands to buttons 1-6
b. Tick the extension keypad
c. Assign commands to buttons 7-12
d. Program MASTER (1-6) device
e. Program SLAVE (7-12) device
f. Connect two devices together with RS-485 terminals. All RS-232, IR, and 12v
trigger cables should be terminated to the master unit.
9.
SCHEDULE LAST
been learnt first.
10. TRANSMIT MODE If multiple commands are part-way through being sent sequentially,
pressing another button will cancel any previously queued commands.
i. Untick box
ii. Connect MASTER device to PC
iii. Select copy to device
i. Tick box
ii. Connect SLAVE device to PC
iii. Select copy to device
If setting up the scheduling function do this last. All of the codes have
13
TC3-CTL_manual_en.doc