Craftsman CMKGAAV45099000 Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
STEP 11
Raising Lift Arm to Locking Position
• Raise the Lift Arm until the Carrier Locking Handle drops into one of the three
Tower Holes. The Tower Locking Holes are the
automaticsafety engagement system.
• The Carrier Locking Handle automatically drops into the Tower Holes as the Carrier
passes the Tower Holes when raising.
Locking engagement occurs at 14", 19" and 24".
NOTE: When lowering the Lift Arm, the Carrier Locking Handle must be held out by
the operator until it clears the bottom Tower Hole.
NOTE: The lift is equipped with a clutch to protect itself from
accidental damage. If the Carrier Locking Handle is not disengaged
when lowering, the clutch will release the Crank Handle from the
screw and rotate freely. To re-engage the Crank Handle,
turn clockwise for a few turns.
STEP 12
Preparing the Mower for Service
• Place wheel chocks (not included) behind the back tires of the mower.
• Apply the parking brake on the mower.
• The Carrier Locking Handle must be locked into one of the
two Tower Holes.
STEP 13
Lowering the Mower
• Remove wheel chocks.
• Release the parking brake.
• Mower must be in neutral or hydraulic drive disengaged.
• Pull and hold the Carrier Locking Handle out and turn the Crank
Handle counter clockwise until Wheel Pads are firmly on the ground.
NOTE: The Carrier Locking Handle must be pulled out until it clears the
bottom Tower Hole. It may be necessary to raise the Carrier slightly to
allow the Carrier Locking Handle to be pulled out.
NOTE: The lift is equipped with a clutch to protect itself from accidental
damage. If the Carrier Locking Handle is not disengaged when lowering,
the clutch will release the Crank Handle from the screw and rotate freely.
To re-engage the Crank Handle, turn clockwise for
a few turns.
14
Carrier
Locking
Handle
Wheel Chock
Tower Locking
Holes are the
automatic
safety engage-
ment system
24" – Third Lock-
ing Hole height
19" – Second
Locking Hole
height
14" – First Lock-
ing Hole height
Tower Holes
Carrier
Locking
Handle

Publicidad

Tabla de contenido
loading

Tabla de contenido