PowerTap Pro Guia De Instalacion

Warnings:

Rotor may become very hot during use. Avoid contact during and
directly after riding.

Rotor may contain sharp edges. Avoid contact while the wheel is spinning.

Installation should only be completed by a trained technician. Improper
installation could cause serious or fatal injuries.

This product is designed for cross country use only.
Maintenance and Break-in:

A break-in period of 30-40 complete, moderate stops is required
for the rotors to reach full braking power.

Disc rotor may be periodically cleaned with Isopropyl Alcohol.

Rotor bolts should be periodically checked for proper tightening torque.

To replace batteries, rotor must first be removed. Refer to page 36 of
owner's manual for additional instructions.
Assembly Instructions:
This kit includes:
1x
160mm PowerTap Disc Rotor
Assemble as shown:
Notes:

Tighten bolts to 55in-lbs, in star pattern.

Optional—M5x0.2mm shims may be used between hub and rotor to center rotor in caliper.
Additional Information/Replacement Parts

For replacement rotors, please contact Saris.

See complete Owner's Manual for additional information.
Saris Cycling Group, Inc. 5253 Verona Road Madison WI 53711 800.783.7257 www.powertap.com
1x
MTB Disc PowerTap Hub
PowerTap Pro Disc Installa on Guide
Hub/Wheel Building Information:

Spoke Holes—32

Disc Rotor Diameter—160mm

Hub Over-Locknut Distance —135mm

Non-drive side flange dimensions:

Flange Diameter—74.0mm
Center to Flange—31.3mm

Drive-side flange dimensions:
Flange Diameter—70.0mm
Center to Flange—18.5mm

IMPORTANT: For your safety, the
non-drive side of the PowerTap hub
must be built with at least a 3x lacing
pattern. Because of the patented
PowerTap design, torque is transferred
through the hub to the non-drive side.
Failure to adhere to this precaution will
void the warranty.
16x M5 x 0.2mm shims
8x
M5 x 12mm bolts
1x T25 Torx Wrench
21609 05/13