Programación Del Vv3 Con Safeline Pro; Tetris Mode; Resetting Vv3; Travelling Direction Arrows And Fi Xed Messages - Safeline VV3 Instrucciones De Funcionamiento

PROGRAMACIÓN DEL VV3 CON SAFELINE PRO
Con el software SafeLine Pro podrá programar las entradas y realizar cambios en los mensajes de texto
fi jos, así como descargarlos al VV3.

TETRIS MODE:

Tetris mode show car travelling direction (instead of arrows) and is displayed by three
scrolling LED's at the right side of the display. To program Tetris mode, use SafeLine
Pro and check the box "Tetris mode (using arrow signals)".

RESETTING VV3:

To reset all confi guration to factory settings:
Keep the two buttons pressed down while connecting the VV3 to supply voltage,release after 5 seconds.
TRAVELLING DIRECTION ARROWS AND FIXED MESSAGES:
Travelling direction arrows and fi xed messages is shown as long as the input is active. When using the
travelling direction arrows the address must be correct (refer to the "Addressing the fl oor indicator"-
chapter on page 10).

POSITIVE/NEGATIVE INPUT SIGNALS:

Floor display VV3 can be programmed for positive or negative input signals. Factory settings are positive
input signal. To program negative input signals, use SafeLine Pro and check the "Inverted input signals"
box.
17
SPANISH V. 2.10
© 2009 SafeLine and all the SafeLine products and accessories are copyrighted by law.
06.2009