Select Blower Option And Install Ductwork - Beat WP28M Serie Manual De Instalación

1. SELECT BLOWER OPTION AND INSTALL DUCTWORK

Either an interior or exterior blower or in-line blower may be used with this hood. The Best WP28M Series must be installed with blower
models iQ6, P3, P6, iQ12, P12, ILB3, ILB6, ILB9, ILB11, EB6, EB9, EB12 or EB15 only.
Other blowers cannot be substituted. (Blowers sold separately.)
Plan where and how the ductwork will be installed.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 up to 7, 10 to 12, 15 and up of this
manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use metal duct tape to seal duct joints.
NOTE: It is recommended that there be a minimum of 6" of straight duct from this hood to an elbow for 8" ducting and 12" for 10" ducting.
DECORATIVE
FLUE
SOFFIT
OR
ABOVE COOKING SURFACE
HH0209A
MODEL iQ6, P3 OR P6
SINGLE INTERIOR BLOWER
TYPICAL DUCTWORK
EXTERIOR BLOWER
DECORATIVE
FLUE
SOFFIT
OR
HOOD
ABOVE COOKING SURFACE
HH0211A
MODEL EB6, EB9, EB12 OR EB15
EXTERIOR BLOWER TYPICAL DUCTWORK
ROOF CAP
8" ROUND
DUCT
12"
WALL
CAP
HOOD
24" 36"
TO
10" ROUND
DUCT
12"
EXTERIOR
BLOWER
24" 36"
TO
DECORATIVE
FLUE
SOFFIT
OR
HOOD
24"
ABOVE COOKING SURFACE
HH0210A
MODEL iQ12 OR P12
DUAL INTERIOR BLOWER
TYPICAL DUCTWORK
10" ROUND DUCT
( HLB3, 8'' ROUND DUCT)
EXCEPT
IN-LINE BLOWER
24" TO 36"
ABOVE COOKING SURFACE
HH0212A
MODEL ILB3, ILB6, ILB9 OR ILB11
IN-LINE BLOWER TYPICAL DUCTWORK
5
ROOF CAP
10" ROUND
DUCT
12"
WALL
CAP
36"
TO
ROOF CAP
WALL
CAP
HOOD