Velleman PCSATA Manual Del Usuario página 4

3. Installation
Notes:
• never apply power to the PCSATA without a device attached.
• never connect more than 1 power supply to a SATA device.
IDE device
• Set the PCSATA for IDE-to-SATA conversion (refer to the
illustration on page 2 of this manual).
• Plug the PCSATA connector [C] on the IDE connector of the IDE
device.
• Plug the SATA-cable from the computer system into the SATA-
connector [B]. Use the included SATA cable if necessary.
• Plug an available power connector into the power connector of the
IDE device.
• Plug the small connector of the included power cable into the power
connector [A] of the PCSATA. Connect the other end to the power
supply of the system.
• Power on the system. The status LED [D] lights up.
SATA device
• Set the PCSATA for SATA-to-IDE conversion (refer to the
illustration on page 2 of this manual).
• Plug the included SATA-cable into the SATA-connector [B]. Connect
the other end to the SATA-device.
• Plug the IDE-connector [C] of the PCSATA into a motherboard or
IDE extension cable (with female connector).
• Plug an available power connector into the power connector of the
SATA device.
• Plug the small connector of the included power cable into the power
connector [A] of the PCSATA. Connect the other end to the power
supply of the system.
• Power on the system. The status LED [D] lights up.
23.07.2009
PCSATA
4 ©Velleman nv