20_27MC4304_1.qx3
04.5.12
AUDIO and VIDEO OUT Jacks on source unit
(VCR or Camcorder)
AUDIO
VIDEO
OUT
OUT
1
Make the connections shown above. Use audio
and video cables (not supplied). Connect the
source unit (VCR or Camcorder) to a power
source after connections are made.
2
The VCR or Camcorder will play your tape. Insert a
prerecorded tape in the source unit. If play
begins, press STOP on the VCR or Camcorder.
3
The TV/VCR/DVD will record your tape. Insert a
blank videotape in the cassette compartment
of the TV/VCR/DVD. Make sure the tape's record
tab is intact and the TV/VCR/DVD power is on.
4
Point the TV/VCR/DVD remote control at the
TV/VCR/DVD. Press SELECT or CH. o/p until
AUX appears on the screen. The TV/VCR/DVD is
now in Line Input or Auxiliary mode.
5
Press SPEED until the desired tape speed (SP
or SLP) appears in the lower left corner of the
screen.
6
Press PLAY on the VCR or Camcorder and
REC/OTR I on your TV/VCR/DVD at the same
time. Videotape copying will begin.
7
To stop copying, press STOP/EJECT C A on the
TV/VCR/DVD, then stop the tape on the VCR
or Camcorder.
11:09 AM
Page 33
Rerecording (Tape Duplication) 33
Audio Cables from
AUDIO OUT to AUDIO In
L
R
Video Cable from
VIDEO OUT to VIDEO In
L AUDIO
R
T
HEADPHONE
VIDEO
AUDIO and VIDEO In Jacks on
front of TV/VCR/DVD
Helpful Hints
• Unauthorized recording of copy-
righted television programs,
videotapes, or other materials
may infringe on the rights of
copyright owners and violate
copyright laws.
• Different brands of equipment
may operate differently.
• Make sure all connections are
secure. Otherwise, you may not
record both picture and sound.
• Programs that are copyright
protected may not record clearly.
• You cannot record a DVD onto a
videotape using this
TV/VCR/DVD.
• You can use this connection to
simply view tapes playing on a
camcorder or VCR at the
TV/VCR/DVD. Follow steps 1, 2,
and 4 for connections and AUX
setup.Then play the tape on the
camcorder, etc., as usual.