Campbell Hausfeld CL154000AV Instrucciones De Operación página 4

Operating Instructions
Operation (Continued)
tool properly will dramatically shorten the
life of the tool and will void the warranty.
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutoMAtiC lubriCAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127000AV or equivalent ISO
grade 32 oil.
MAnuAl lubriCAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
Air Inlet
(Oil Here)
Safety
Blade
Figure 2
4. Connect the air tool to the air supply.
Run the tool in both the forward and
reverse directions, if applicable, for
20 to 30 seconds. Oil will discharge
from the exhaust port when air
pressure is applied.
5. Use steady, even pressure when
using tool. Do not force. Too much
pressure can cause blade to break or
overheat.
6. Choose the correct blade for the
material being cut (Chart 2).
Throttle
Lever
Exhaust
Port
Saw Blade