Troubleshooting - oneConcept 10034476 Manual Del Usario

EN
Memory Selling: Adjust the desk to your desired position. Press the "M"
button, then "S-" appears on the display. Press "1", "2" or "3".
The memory is successfully set. You can store up to 3 heights by repeating the
same process.
Protective Standby Mode: If there is no operation for 1 minute, the system
will enter the protective standby mode. To turn off the standby mode, press
and hold the "M" button for 3 seconds. You can also press and hold the "M"
button for 3 seconds to activate the standby mode, when you don't need to
operate the system.
Power-saving mode: When no actions are made for over 10 minutes, the
system will enter power-saving mode. Press any buttons to enter operation
mode.
Measurement Switch (cm/inch): Press "T" for 8 s. The buzzer will beep twice.
The measurement is changed from centimeter to inch. If you want to switch
the measurement back to centimeter, also press the "T" for 8 s.
Reset Mode: While the system is reconnected, press the down button until
"RST" is displayed. Continue to press the button. The desk will move down
and then raise a little bit. (Make sure you never release the button during the
process.) After the movement stops, the system is successfully reset to the
starting position.

TROUBLESHOOTING

This repair guide intends to help you identify and solve the minor problems
caused by unusual operation of the electric system of our sit-stand desk. The
simple procedures in this manual are easy to follow and capable of solving the
most problems happened in everyday use.
If "ER1/ER2/HOT/ER3/ER4/ER5" appear on the control panel, this is normally
nothing to worry about, and usually is an indication that the system has
experienced activity that is above rated specifications. Simply follow the steps
below, most errors can be solved. If the problems aren't solved, please contact
your point of purchase to replace components.
55