Perel Tools CCTVSETW1 Instrucciones De Inicio Rapido página 7

1. Insert an SD card into the monitor [5] (up to 32 Gb).
2.
Connect the power adapter to the monitor and then to a wall outlet [1].
3. Flip out the camera stand [4].
4. Press and hold the power button for about 3-4 seconds [2].
A Welcome screen appears for a few seconds, then the camera view appears.
Mounting the camera
See images B1 to B3 on page 3.
1. Attach the camera mount at about 2.5 m from the floor.
2.
Loosen up the thumb screw.
3. Choose a proper viewing angle and secure the joint.
4.
Mount the camera onto the bracket
Note: SD card
•
If you are planning to record long videos, it is recommended to use a SD card with high capacity.
•
Always turn off the display before removing an SD card.
7. Use
Parts of the screen
Turn on the the display
•
Press and hold the Power button for about 3-4 seconds.
A Welcome screen appears for a few seconds, then the camera view appears.
Turn off the display
•
Press and hold the Power button until the display shuts off.
Camera modes: quad view and full screen
•
When you switch on the display, the display shows the quad view (up to 4 cameras in a single
screen).
•
Tap one of the camera views to display it full screen.
•
Tap on the full view to return to quad view.
Zooming
•
Zooming only works in full screen view.
•
If the display is in quad view, tap a camera view to set it full screen.
•
Tap the Zoom icon.
•
Select the area you want to zoom in.
Tap the zoom out icon to turn off zoom.
o
Tap again to return to full screen view.
o
Manually recording video
•
In quad view, tap the Record icon.
•
The icon flashes during recording.
•
Tap the icon again to stop recording.
V. 02 – 07/01/2014
CCTVSETW1
1
2
3
4
5
6
7
8
7
pop-up menus
SD card status
battery status
internet connection status
record status
camera number - signal strength
motion indicator
pop-up menu tab
©Velleman nv