Brinkmann 842-A250-0 Manual Del Propietário página 6

READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY.
• DO NOT allow gasoline or other flammable vapors or liquids to come in contact with stove while
lighting or at any time during use of stove.
Step 1
Make sure "Gas Leak Testing" from page 4 was completed
and the burner control knobs are in the "OFF" position and
stove is on a flat surface away from combustible material.
Step 2a Built In Ignition
Decide which burner to light first. Turn the burner control
knob SLOWLY counter-clockwise while turning igniter
knob several times until the burner lights.
Step 2b Match Lighting
Decide which burner to light first. Using a match, hold the
flame beside burner. Turn the burner control knob
SLOWLY counter-clockwise until the burner lights.
WARNING: If the burner does not light within 5 seconds, turn
the burner control knobs "OFF" immediately. Wait
at least 5 minutes until gas fumes have dissipated
before attempting to light burner again.
Step 3
To light the second burner, reduce the flame on the first lit
burner and repeat Step 2 to the other burner.
WARNING: If second burner does not light within 5 seconds,
turn the burner control knobs "OFF" immediately.
Wait at least 5 minutes until gas fumes have
dissipated before attempting to light burner again.
Step 4
Adjust burner flame as necessary by using burner control
knob. Turn stove "OFF" using burner control knobs when
stove is not in use.
Step 5
Allow stove to cool completely, then follow instructions in
the "After-Use Safety" and "Proper Care & Maintenance"
sections of this manual.
ON / Larger Flame
OFF / Smaller Flame
5
OPERATING INSTRUCTIONS
WARNING
Note: Observe flame height and
color when lit. Flame
should have a blue center
and a slight yellow tip.
Igniter Knob
Match
Minimum clearance to
combustibles 36 inches from top
and side of stove burners
Perimeter of base of stove
Burner
Burner Control Knob
Burner Control Knob
36"
36"
Yellow
Blue