Publicidad
Idiomas disponibles
Idiomas disponibles
View
blue indicator
Wireless window contact
(magnetic)
Wireless window
Notch to open of the
contact (transmitter)
battery compartment
Volume setting/Melody selection
Press the "Volume"/"melody forward/backward" button until you hear the
required volume/melody.
You can change the volume at any time and this is independent of the
corresponding transmitter. The last selected volume is automatically saved.
You can still replay different bell tones by pressing
"Melody forward/backward". This does not effect the
saved bell tone when coding between transmitter and receiver.
Installation
Choose a suitable location for the chime and motion detector. Check the selected
location for wiring before drilling any holes.
Tip: Test the desired function before ultimately installing the device at the place
of installation you chose.
Stick both parts of the window contact onto a smooth and clean surface. To
do so, remove the protective film on the rear side of the tape. Press down on
the parts for at least 10 seconds, to create a good adhesive bond. Observe the
maximum distance of 1cm between both parts.
Note:
• Avoid the effect of direct sunlight and water (e.g. caused by high humidity)
because this can affect the adhesive power of the window contact.
• It does not matter whether the magnetic part of the window contact is installed
on the right or left side of the transmitter component.
12
battery compartment
Troubleshooting
Error
Error correction
description
The chime
•
Check the batteries of the receiver (chime) and the
does not
transmitter (bell push, motion detector, window
contact). Change the batteries if necessary.
sound
•
Check whether the distance between the receiver
(chime) and transmitter (bell push, motion detector,
window contact) is too far. If necessary, reduce the
distance, to get back within the range.
•
Check whether the receiver (chime) is coded with
the transmitter (bell push, motion detector, window
contact). If necessary, code the receiver and transmitter
as described above.
•
Check the volume setting of the receiver (chime).
Increase the volume if necessary.
Range is low
•
Check the mounting surface and the surroundings.
Metal surfaces can reduce the range. Avoid installation
on or near metal.
•
Structural conditions (e.g. concrete walls or ceilings)
can have an effect on the range.
•
Other wireless products in the vicinity can have an
effect on the range. Change the location of the receiver
(chime) and/or transmitter (bell push, motion detector,
window contact) or the other wireless product.
•
Check the batteries of the receiver (chime) and
transmitter (bell push, motion detector, window
contact). Change the batteries if necessary.
13
Publicidad
