Grandstream GVR3550 Guía De Instalación Rápida página 4

INSTALL THE HDD:
1. Install the supplied screws to the 4 holes on the
bottom of HDD loosely.
2. Remove the 8 screws on back and side panel of the
device then open the cover panel.
3. Side standing the opened device so the screws holes
at the floor shell can be easily spotted.
4. Put the HDD (with 4 screws on) into the holes on floor
shell, sliding it to narrow opening, tighten the 4 screws.
5. Repeat the above steps if having multiple HDDs.
~ ~
3
6. Connect the SATA power and data cables from HDDs
to the PCB board.
7. Close the cover panel and tighten the 8 screws.
~ ~
4