Setting The Number Of The Minimum Management Group - Mitsubishi Electric PAC-SF41SCA Libro De Instrucciones

7-1-1. Setting the number of the minimum management group

Sets the number of the minimum management group using the system remote controller.
(The minimum management group = 1 is set when shipped.)
Groups managed with the system remote controller.
Groups between the minimum management group number and the minimum management group + 31.
Examples:Groups 1 - 32 are managed when the minimum management group = 1.
Groups 12 - 43 are managed when the minimum management group = 12.
The minimum management group number set with this function appears as a group number in the block at
the top-left of the display.
Example: When the minimum management group = 12
Group number : 12
CENTRALIZED
COLLECTIVE
ON OFF
GROUP
Changing the Minimum Management Group Number
PROHIBIT
(1) Press the switch twice in the initial setting mode.
The block at the top-left is selected and the current minimum management group number is displayed.
(2) The minimum management group number is incremented each time the
decremented each time the TEMP.
NOTE: • The minimum management group number may be set between 1 and 50.
• When the minimum management group number is set to 20 or higher the group number for the
block for the corresponding group will exceed 50. In this case indoor units cannot be registered
in the block for which the group number is 51 or higher.
(3) After selecting the minimum management group number in (2) above, press the
register the new minimum management group number.
NOTE: The minimum management group number setting is necessary when the system remote controller
is set up as either a master or slave. (This is not necessary if the minimum management group
number remains at the default value of 1 set before shipment.)
ON/OFF
PROHIBIT
CHECK
ON/OFF FILTER
AUTO
MODE TEMP.
BY-PASS
MODE LOCK
HEAT EX.
SKIP
FILTER
˚C
switch is pressed.
12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27
28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43
Group number of each block
switch is pressed, and
PROHIBIT
switch twice to
15