Heater Operation - Comfort Glow QEH1410 Instrucciones De Instalación Y El Manual De Propietario

HEATER OPERATION

Control Panel
Remote Control
Plug your comfort furnace power cord into a 120V, 15amp grounded receptacle.
Note: When programming your comfort furnace the display will flash until your request
is accepted by the heater. This will occur when using both the control panel and the remote
To Turn the Heater On: Turn on the main power on/off switch on the rear panel of the
heater. Then press the Power button on the control panel or on the remote control. Your
display panel will flash then show the ambient room temperature.
To Set the Temperature: Press up or down button on the control panel or on the remote control to
the desired temperature when desired temperature is reached, the heater will stop heating
automatically. When temperature drops below the desired temperature, the heater will come on
again. Note: After setting the desired temperature and the display digits stop flashing, the actual
room temperature will be displayed. To check set temperature at anytime simply press the temperature
arrows on the control panel or the remote control. The heater will not turn on until the room temperature is below the
desired temperature you have selected.
To Set the Power Level: Press the heat button on the control panel or remote control to
switch between high and low heat and the corresponding High (H) or Low (L) LED will be lit.
L=750W H=1500W
To Set Timer: Press Time button on the control or remote control, numbers 0 to 8 will appear on screen.
0 means there is no set running time and heater will run continuosly. Number 1-8 means the number of
hours that the heater will run before it automatically stops.
To Change between °C and °F: Press the converter button on the control panel or remote control.
C=Centigrade F=Fahrenheit
~ 5 ~