Cord wrap facility (specific types only)
If your Sonicare type includes the deluxe charger
cover and base, the travel charger is pre-installed
inside the cover. If you want to shorten the mains
cord, you can store excess cord in the cord wrap
facility in the charger base.
1
To separate the charger cover from the
charger base, press the two grey snap bars on
the charger base and pull the white charger
cover upwards.
2
Wrap excess mains cord around the grey
charger base as shown in the picture. Make
sure you wrap the cord on the inside of the
two snap levers.
3
When you have stored the excess cord, guide
the mains cord through the small groove in the
rear of the grey charger base.
4
To reattach the charger cover, press it down
over the charger base until it snaps into place.
Tip: For extra convenience during travel, you can
remove the travel charger and use it without the
charger cover and charger base.
EnglisH
13