Danze Orrington Serie Instrucciones De Instalación página 5

8. Press plastic anchors (C) into the holes until
they are flush against the surface. Use a hammer
if necessary.
9. Set the vanity (A) back to the intended posi-
tion, aligning holes with anchor positions.
10. Install the wall anchor hardware with a Phil-
lips screwdriver in the following order: flat
washer (S), plastic washer (D), spring washer (E),,
wood screw (F), and metal cap (G).
7
11. Install the Orrington™ self-rimming lavatory
according to the installation instructions provid-
ed with the lavatory. The top of your Orrington™
vanity (A) features a channel custom fit for your
lavatory to provide a solid seal and clean, straight
lines.
12. Install the knobs (H) on the doors with the
bolts (I) using a Phillips screwdriver.
13. If needed, door hinges can be adjusted for
height and depth by loosening the hinge screws
on the inside and positioning them to the appro-
priate location.
Please refer to Homeowner Care Manual for troubleshooting, care and mainte-
nance information.
8