Versaclean 200MP Manual Del Usuario página 3

FIG. 2: Rear View
A
C
A Solution tank with clear hinged cover
B Wand retention clip
C Vacuum exhaust. Keep clear.
D Product label and serial number
E Auto-pumpout coupling. Keep capped when
operating without drain hose installed.
CAUTION: When the recovery tank reaches capacity,
an automatic float valve blocks vacuum intake
(Fig. 5) and the vacuum motors will make a high
pitched noise. When this occurs, switch the machine
off immediately to prevent damage to the vacuum
motors and drain waste tank as described in Step 8.
FIG. 4: Solution inlet filter cleaning
Unscrew
inline filter
cap assembly
and remove.
07-02091D F561-MP
A
B
D
E
FIG. 3: Control Panel
SWITCH POSITIONS
I CLEAN EXTRACT
O OFF
II FLOOD EXTRACT
AFTER CLEANING:
1. When cleaning is completed, rinse solution tank with
clear water to ensure no detergents or rinse agents
remain in the tank. Use the vacuum hose to remove any
remaining liquid.
2. Empty and rinse the waste tank thoroughly. This will
help to prevent the formation of damaging deposits and
reduce the growth of odor-causing bacteria.
3. Turn on Clean Extract switch and allow it to run for 5
minutes to help remove any moisture from the vacuum
motors and help ensure long vacuum life.
SET UP FOR FLOOD EXTRACTION
Step 1: Connect supplied hose to waste tank pumpout
valve (Fig 2E).
Step 2: Place pumpout hose in toilet or other suitable
drain.
Step 3: Select Flood Extract mode.
Step 4: Extract surface water by pulling the wand toward
you across the surface, applying pressure as you pull.
NOTICE: Do not submerge the wand head in
standing water and do not place the end of the
vacuum hose under the surface of the water.
Submerging the end of the vacuum
hose while operating the unit can
cause severe damage to the unit and
void the warranty.
AFTER EXTRACTION:
Rinse cap 1. Manually drain waste tank: remove
and filter
cap from the black drain hose on front
assembly
of unit (Fig. 1D) and dump into toilet or
clean and
other drain, or use the automatic
reinstall.
pumpout feature described below.
2. After flood extraction is complete,
empty waste tank, then rinse and empty
3 VersaClean