Power Supply - SINCO SS 4036 Manual Del Usario

5. General information about calluses
Calloused skin is normal, especially on the feet. However, it should not become too thick or hard.
Both of these conditions can cause pain.
Causes
An increase in calloused skin can be caused by the wrong shoes, obesity, an incorrect gait, bone deformations
or extremely dry skin. Should you suffer from an increase in calloused skin, you should search for the causes
and try to eliminate them. Also ask your doctor.
Prevention
• Regular foot baths refresh and relax your feet.
• Moisturise your feet regularly (especially after every foot bath).
• Make sure that your shoes fit well and, if possible, change your shoes daily.
6. How to use
• Remove all packing material.
• Check that the delivery is complete.

6.1 Power supply

WARNING! Risk of material damage! Be sure to observe the correct polarity when inserting the batteries.
1. Slide the battery compartment lid off the housing.
2. If necessary, replace the old batteries with new ones.
3. Slide the battery compartment lid back on to the housing.
6.2 Attachment and removal of roller holder
Attachment
1. Figure A: Pace the roller holder 2 on the top of the device in such a way, that the cog wheels of the roller and
the devices are above one another.
2. Press the roller holder 2 on to the device until it engages audibly.
3. Check that it is secure.
7. Operation
Two complete rollers 1/8 with roller holders 2 are supplied. They have different grains.
• The coarser grain (turquoise roller 8) is for use on thick callus
• The finer grain (purple roller 1) also removes calluses, but also smoothes them. The roller is especially suitable
for smoothing after having used the coarser roller 8.
WARNING!
Exert only light pressure. Do not treat one spot longer than 2-3 seconds. If too much pressure is exerted or if
the treatment duration is too long, this can lead to skin injuries.
7.1 Application
• Make sure the skin is dry.
• It is imperative that the skin is taut.
• Stop the treatment immediately in case of pain.
• Lay a blanket or towel down, on which the removed calloused skin can fall.
1. Expose the parts from which the calluses are to be removed.
2. Press the safety button 4 down and then press the slide switch 3 up. The roller 1/8 starts to rotate.
3. Apply the rotating roller slowly and carefully to the callus, which is to be removed.
4. Apply the roller 1/8 to the callus with only a little pressure.
5. To switch off the device, slide the button 3 down.
7.2 Skin care after application
• Apply body lotion, oil or cream to the skin.
• Do not apply any substances to the treated areas, which could irritate the skin (e.g. deodorant).
- 8 -