Safety Warning - Marmitek CM11-SERIAL Manual Del Usario

SAFETY WARNING

• To prevent short circuits, this product (except the outdoor camera) should only be used
inside and only in dry spaces. Do not expose the components to rain or humidity. Do not
use the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright
light sources.
• Do not open the product: the device contains live parts. The product should only be
repaired or serviced by a qualified repairman
• In case of improper usage or if you have opened, altered and repaired the product your-
self, all guarantees expire. Marmitek does not accept responsibility in the case of improp-
er usage of the product or when the product is used for purposes other than specified.
Marmitek does not accept responsibility for additional damage other than covered by the
legal product responsibility.
1 INTRODUCTION CM11-SERIAL
The Marmitek CM11-serial can be used to connect the Marmitek ActiveHome and the CM11
computer interface to the serial port of your PC.
1.1 INSTALLATION OF THE SERIAL CABLE
This cable has an RJ-10 4P4C connector on one side and a 9-pin 'D' connector on the other.
The 9-pin 'D' connector is connected to a free 9-pin serial COMM port on your PC.
Remember the port number of your PC. You will need this to install ActiveHome.
1.2 INSTALLING ACTIVEHOME
You have to reinstall ActiveHome after you installing the CM11-SERIAL (your configuration
files will not be changed).
1. Install ActiveHome from the ActiveHome CD included. You can download the most
recent version of the software from: www.marmitek.com > customer service
2. When the window "CAUTION COMMUNICATION PORT" opens, select YES (Figure 1).
3. Click Next.
4. Select the COM port the CM11-serial is installed on (Figure 2: COM1, 2, 3 of 4).
5. Follow the instructions on your screen to complete the installation.
2
Figure 1
Figure 2
MARMITEK