Using The Boomboom 577; Activating The Boomboom 577; Volume Controls; Switching Off - Marmitek BOOMBOOM577 Manual Del Usario

4.2

Using the BoomBoom 577:

You can use your BoomBoom 577 to listen to music, make phone calls and even pair it
with 2 smartphones.
4.2.1

Activating the BoomBoom 577

Press and hold the power button for 2 seconds. The BoomBoom 577 will now produce
a "start-up" tone. The blue LED will start flashing.
The BoomBoom 577 will now automatically connect to the last smartphone it was
paired with. Once this link is established, the blue LED will flash slowly. Two
smartphones can be simultaneously connected to the BoomBoom 577. If your
smartphone does not automatically make a connection, please go to your
smartphone's Bluetooth settings and select BoomBoom 577. A connection will then be
established.
4.2.2

Volume controls

1. Tap volume + to increase the volume. When the maximum volume is reached, an
audible indication will sound.
2. Tap volume - to decrease the volume. When the minimum volume is reached, an
audible indication will sound.
4.2.3

Switching off

Press and hold the power button for 4 seconds to switch off the BoomBoom 577.
The red LED will light up and slowly fade out; you will hear a sound to confirm that the
BoomBoom 577 is switching off.
Note: BoomBoom 577 will switch off automatically after 10 minutes if it's not connected
to a device.
4.2.4

Connecting two smartphones, multi-pair.

If the BoomBoom 577 was paired with a smartphone previously, it is possible to pair
the BoomBoom 577 with a 2
Switch off the BoomBoom 577 and follow 4.1.2 Pairing Bluetooth devices to pair the
BoomBoom 577 with the second smartphone. Then pair the first smartphone with the
BoomBoom 577 again. Now, both smartphones are connected to the BoomBoom 577.
You can now use the first smartphone to play music. When you stop the music on the
first smartphone, the music of the second smartphone will be displayed. This allows
you to play music alternating between both smartphones.
4.2.5

Connecting to the last paired smartphone.

After switching on the BoomBoom 577, it will connect with the last paired smartphone.
If the connection is successful, the LED will blink every 3 seconds in standby mode.
Note: If the connection cannot be made within 10 minutes, the BoomBoom 577 will
switch off.
The BoomBoom 577 can remember up to 8 paired devices. Therefore, re-pairing with
each subsequent connection is not required. If a 9th device is paired with the
BoomBoom 577, the first smartphone that was paired with the BoomBoom 577 will be
erased from its memory.
BoomBoom 577™
nd
smartphone.
7