Initial Setup Via Bluetooth; Volume Control - Marmitek BoomBoom 150 Manual Del Usario

INITIAL SETUP VIA BLUETOOTH

1. Turn on the BoomBoom150/152 by pressing the POWER
button.
2. Wait for approximately 20 seconds. The speaker will go
into pairing mode and will produce a "beep" tone. The
red & blue lights will then flash alternately.
3. Turn on a device that supports Bluetooth, such as an iPod,
iPhone, Android or mp3 device and go to: Settings >
General > Bluetooth. Click ON the Bluetooth.
BoomBoom150/152 will then appear on the device. Click
ON the BoomBoom150/152. The device is now connected
and paired with the speaker. If the device prompts for a
pair code, enter:"0000"
4. If the pairing failed within 150 seconds, the system will
search for the last paired device and the blue LED will
flash slowly. To restart the pairing process, turn off the
speaker and repeat step 1. If the initial setup connection
is successful, the next time the speaker is turned on, the
speaker will automatically pair to the last device it was
connected with.
! You can link to up to 8 devices however only 1 device can be
connected to the BoomBoom150/152 at one time.

VOLUME CONTROL

1. Tap VOLUME+ for 1 second increments to increase the
volume. When maximum volume has been reached, a
tone indicator will sound.
2. Tap VOLUME- for 1 second increments to decrease the
volume. When minimal volume has been reached, a tone
indicator will sound.
3. Press VOLUME+ for 2 seconds to listen to the next song.
(NOTE:THIS FEATURE MAY NOT WORK WITH SOME BLUETOOTH DEVICES)
4. Tap VOLUME- for 2 seconds to listen to the previous song.
(NOTE:THIS FEATURE MAY NOT WORK WITH SOME BLUETOOTH DEVICES)
4 © MARMITEK