Important Safety Instructions - Iberspa READY2ENJOY Manual De Funcionamiento

IMPORTANT SAFETY INSTRUCTIONS

The following instructions are required to be printed by Underwriters Laboratory (U.L.)
as well as ETL Testing Laboratories, Inc. as a condition of their listing of this product.
They contain important safety information, and we strongly encourage you to read and
apply them.
1. When installing and using this electrical equipment, basic safety precautions should
always be followed, including the following:
A. READ AND FOLLOW ALL INSTRUCTIONS.
B. A green colored terminal or a terminal marked G, GR, Ground, Grounding, or the
ground symbol is located inside the supply terminal box or compartment. To
reduce the risk of electric shock, this terminal must be connected to the
grounding means provided in the electric supply service panel with a continuous
copper wire equivalent in size to the circuit conductors supplying this equipment.
C. At least two lugs marked "BONDING LUGS" are provided on the external surface
or on the inside of the supply terminal box or compart-ment. To reduce the risk
of electrical shock, connect the local common bonding grid in the area of the hot
tub or spa to these terminals with an insulated or bare copper conductor not
smaller than NO. 6 AWG.
D. Temperature Control of your Spa. To set desired temperature, push the up or
down heat button on the display.
temperature set point. To raise set point, push up button for each additional
degree of water temperature to a maximum 104ºF (40ºC).
button to lower the water temperature set point.
2. WARNING - To reduce the risk of injury, do not permit children to use this product
unless they are closely supervised at all times.
3. A wire connector is provided on this unit to connect a minimum No. 8 AWG (8.4
2
mm ) solid copper conductor between this unit and any metal equipment, metal
enclosures of electrical equipment, metal water pipe, or conduit within 5 feet (1.5
m) of the unit.
4. DANGER - Risk of injury.
A. If supply cord is damaged it must be replaced by the manufacturer, its service
agent, or similarly qualified persons in order to avoid a hazard.
B. Do not bury cord.
C. Connect to a grounded, grounding type receptacle only.
5A. WARNING - For 120 volt versions: This appliance is provided with a ground-fault
circuit interrupter (located near the end of the power supply). With the unit
operating, push the test button. The unit should stop operating and the reset button
should pop out slightly. Push the reset button. The unit should now operate
normally. If the interrupter fails to operate in this manner, there is a ground current
The display will flash current water
ENGLISH
Push the down