Publicidad
Idiomas disponibles
Idiomas disponibles
Orange Wire: Accessory Output
Connect this wire to the Accessory wire from the ignition switch. This wire will show
+ 12 Volts when the ignition switch is turned to the "ACCESSORY" or "ON" and "RUN"
positions, and will show 0 Volts when the key is turned to the "OFF" and "START" or
"CRANK" positions.
Wiring The 2 Pin Door 1 Wire Unlock Harness Connector (P/N 4120104)
The Blue Door Unlock output wires provide a pulsed ground output to control the vehicle
door unlock circuits. The output of this wire has a maximum switching capability of 250 mA.
Many vehicles today have factory door lock relays which can be connected directly to this
output, however always confirm that the factory relays in your particular vehicle do not
exceed the rated 250mA output of the units door unlock circuit. Plug the 2 pin connector of
the door unlock harness into the mating connector shell of the control module. Determine
the door unlock circuit of the vehicle you are working on and wire according to the diagrams
shown.
3 Wire Negative Switched Door Lock Circuits:
In this application, the Blue wire of the 2 pin harness provides a negative pulse during the
unlocking sequence. Connect the Blue wire to the low current negative signal wire from
the factory door unlock switch to the factory door unlock relay.
Negative Type Door Lock Circuits
Page 4
128-9239
4 of 24
Publicidad
