Tomahawk TMD14 Manual De Usuario página 9

ON
(4) Starting Cold
Please operate according to the following
procedures:
a.Press oil cup 2-3 times until it fills with gasoline
and see Fig.6.
b.Set the throttle handle to the stop position,see
Fig.8.
c.Set the choker on the full position,see Fig.7.
d.Pull the starter for a few times and let it
retract slowly.Do not let the handle to retract
freely to avoid damage of the starter.
Fig 6
Fig 7
OFF
Fig 5
e.Close the choker and pull starter handle
f.After starting the engine,open choker fully.
g.Let the engine run at low speed for 2-3
minutes,then start the spraying or dusting
operation.
(5)Starting the engine warm
a.Leave the choke fully open.
b.If the engine draws in too much fuel.Leave
the fuel switch fully closed ,pull the starter 5-6
times.Then start the engine as explained above.
(6)Stopping the engine
a.Set the two control handles to their lowest
positions until the engine stops.
then stop the machine.
c.Having finished working, turn off the fuel
switch.
Note: While the engine is running, the hose
must be mounted to the machine, otherwise
cooling air will be reduced and this can
damage the engine.
-8-
Fig 8