Electrolight Operational Guidelines; Charcoal; Fireplaces And Pits; How To Use - Homeright Electrolight C900046 Manual De Instrucciones

CHARCOAL

The ElectroLight ignites charcoal with super heated air,
then uses the blower to fan the flames. No need for
starter fluids and faster than a chimney.

FIREPLACES AND PITS

The ElectroLight is used to preheat the flue and create a
positive draft. Its super heated air lights firewood, then
uses the air to fan the flames. No need for fire starters
or paper.

HOW TO USE

While pulling the trigger, touch the tip of the ElectroLight
to the charcoal or firewood kindling. In 15 to 30 seconds
you will begin to see glowing spots.
Pull the tip back approximately 3" and continue for another
minute or two.
Easily restarts fires – when the fire burns down but not
out, add more wood and use the ElectroLight to get it
roaring again.
ELECTROLIGHT SPECIFICATIONS
Temperature
Power Rating
Power Source
Cord Length
Warranty
When the trigger is pulled, cool air is drawn into the ElectroLight, flows over heated coils and out through the end at 1300° F.
C900046 ElectroLight Hot Air Fire Starter

ElectroLight Operational Guidelines

1300° F (704° C)
1500 Watts
120 Volts
10 feet
2 Years

CLEANING AND MAINTENANCE

Never allow any liquid to get inside the ElectroLight or
immerse any part of the ElectroLight into a liquid. Ensure
the intake openings and the housing are clean and free
of obstructions.
If necessary, use a soft, dry brush to clean the intake
opening and housing. Use only mild soap and a damp
cloth to clean the ElectroLight housing. Do not use
house-hold cleaners, since many contain chemicals,
which could seriously damage the ElectroLight housing.
Do not use gasoline, turpentine, lacquer, paint thinner,
dry cleaning fluids or similar products. Do not clean
ElectroLight while turned on or plugged in.

STORAGE

Let the ElectroLight nozzle cool to room temperature
before placing it in storage. Over time, the gun's high
heat will discolor the nozzle. This is normal and will not
affect the performance or life of the tool.
• WARNING: Do not at any time let brake fluids,
gasoline, petroleum based products, penetrating oils,
etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.

LUBRICATION

This tool is permanently lubricated at the factory and
requires no additional lubrication.
ENGLISH 6