Feiss F 502 M Manual Del Usuario

Installation Instructions for
Marteau Flush Mount
Ceiling
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing
junction boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
1A
FIXTURE BASE
BOTTOM SHADE RING
1 1
Secure the mounting plate to the electrical box with two mounting plate screws.
2
Connect the fixture to a suitable ground in accordance to local electrical codes.
3
Connect the white fixture wire to the neutral power line wire with a wire nut.
4
Connect the black fixture wire to the hot power line wire with a wire nut.
1 5
Place the fixture base onto the mounting plate studs and secure them in place by tightening the ball nuts.
6
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
7
Place the top shade ring and the shade onto the fixture base and secure them in place with the cap nuts.
8
Screw the side of the threaded nipple with the pre-installed nut into the fixture base.
9
Install the bottom shade ring and diffuser, then secure them in place with the finial.
I :
NEC compliant
1
7
LAMP
6
DIFFUSER
FINIAL
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
MOUNTING PLATE
4 3
5
8
6
9
1
CAUTION RISK OF FIRE -
BALL NUT
TOP SHADE RING
SHADE
CAP NUT
THREADED NIPPLE
F 502 M
1.0
F 502 M