SOL Republic SHADOW FUSION Manual De Instrucciones página 4

SETUP
PAIRING YOUR EARBUDS
6 EN
CHARGING EARBUDS
To charge the earbuds, open the
charging port on the bottom of the
neckband on the left side. Plug the
small end of the USB cable into the
charging port on the neckband and
plug the large end of the USB cable
into a power source.
LED INDICATION
While charging, the large LED light
will be red. A full charge will take
approximately 1 hour. When fully
charged, the large LED light will
be blue.
STEP ONE
To pair your earbuds, make sure the
®
Bluetooth setting on your mobile
device is turned on.
STEP TWO
Turn on your earbuds by pressing
and holding the power button for
3 seconds. The power button
is located on the bottom of the
neckband on the left side. The large
LED will flash red and blue when
searching for a device.
STEP THREE
Select "Shadow Fusion" from the
Bluetooth ® list on your mobile device.
Once the earbuds are connected, the
large LED light will pulse blue.
UNPAIR YOUR EARBUDS
MULTI-POINT
Multi-point pairing allows you to connect two devices simultaneously. Once
paired, the Shadow Fusion can receive or make calls from both devices.
To turn on multi-point, make sure your Shadow Fusion is connected to a device
and follow the below steps:
STEP ONE
To unpair your earbuds, press the
round multi-function button on top
of the neckband on the left side for 5
seconds. You will hear a voice prompt
stating the earbuds are ready to pair.
STEP ONE
Make sure music is paused and
phone calls are disconnected. Press
the multi-function button and
volume down button once at the
same time. A voice will state that the
earbuds are ready to pair.
STEP TWO
Connect the second device first
following the steps under "Pairing
your Earbuds."
STEP THREE
Once connected to the second device,
you must re-pair the first device. Now,
both devices will be connected.
STEP FOUR
To turn off multi-point, simply press
the multi-function button and volume
down button once at the same time.
EN 7